Sunday, October 31, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 1565

2010 Cadillac Truck SRX FWD V6-3.0L Page 1565



1. Engine running, accessories OFF, measure and record the battery voltage at the C1 battery terminals. The voltage should be between 12.6 and



15.0 V.



瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests



and General Diagnostics/Charging System Test).



2. Engine running, observe the scan tool of the appropriate control module Ignition 1 signal parameter. Verify that the scan tool displays a value



that is within 2 V of the battery terminal voltage.



瀚慖f not within the specified range, replace the appropriate control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for the appropriate control module replacement, setup,



and programming



P0564



DTC P0564, P0567, or P0568



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptors



DTC P0564



- Cruise Control Multifunction Switch Circuit



DTC P0567



- Cruise Control Resume Switch Circuit



DTC P0568



- Cruise Control Set Switch Circuit



Diagnostic Fault Information



Circuit/System Description



The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate



and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function.



The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The BCM sends a serial data



message to the engine control module (ECM) indicating the status of the cruise control switches.



Conditions for Running the DTC



* The cruise switch is ON.



* The ignition is ON.



Conditions for Setting the DTC



* The BCM detects an invalid voltage signal on the cruise control switch signal circuit for greater than 2 seconds and sends a serial data



message to the ECM. The ECM sets these DTCs when the message is received.



* The ECM runs this diagnostic every 0.05 second.

No comments:

Post a Comment