2010 Cadillac Truck SRX FWD V6-3.0L Page 648

2010 Cadillac Truck SRX FWD V6-3.0L Page 648

The BCM detects that a window motor is "not normalized" which will occur under the following conditions:

* When the battery has been disconnected

* When the battery has been replaced

* When the door wiring harness has been disconnected

* When the window motor has been disconnected.

Action Taken When the DTC Sets

B3205 00, B3205 39, B3205 42, B3210 00, B3210 39, B3210 42, B3215 39, B3220 39

The affected motor will be inoperative.

B3205 4B, B3210 4B

The affected motor will not perform the express up or express down functions and the driver information center will display Open, then Close

Driver Window or will display Open, then Close Passenger Window.

Conditions for Clearing the DTC

B3205 00, B3210 00

Installing a compatible window motor for that specific make and model vehicle.

B3205 39, B3210 39, B3215 39, B3220 39

If the DTC is current, the appropriate window motor must be replaced before the DTC can be cleared.

B3205 42, B3210 42

The appropriate window motor must be replaced before the DTC can be cleared.

B3205 4B, B3210 4B

The appropriate window motor must be normalized before the DTC can be cleared.

Reference Information

Schematic Reference

Moveable Window Schematics (See: Windows and Glass/Windows/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Power Windows Description and Operation (See: Windows and Glass/Windows/Description and Operation/Power Windows)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

B3205 00, B3205 39, B3205 42, B3210 00, B3210 39, B3210 42, B3215 39, B3220 39

1. Ignition ON, command the M74 window motor UP and DOWN with a scan tool. The M74 window motor should perform the UP and

DOWN functions.

Note: If the window performs the UP and DOWN functions, clear the DTC