2010 Cadillac Truck SRX AWD V6-3.0L Page 1627

2010 Cadillac Truck SRX AWD V6-3.0L Page 1627

ECM.

4. Ignition ON, test for 2-3 V on the enable circuit terminal 20 of the fuel pump control module.

瀚慖f not within the specified range, replace the K20 ECM.

5. If all circuits/connections test normal, replace the K27 fuel pump control module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM or fuel pump control module replacement, setup,

and programming

P0630

DTC P0601-P0604, P0606, P0607, P0610, P062B, P062F, P0630, P16F3, or P2610 (ECM, LF1/LFW/LWR)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0601

- Control Module Read Only Memory Performance

DTC P0602

- Control Module Not Programmed

DTC P0603

- Control Module Long Term Memory Reset

DTC P0604

- Control Module Random Access Memory Performance

DTC P0606

- Control Module Processor Performance

DTC P062B

- Control Module Fuel Injector Control Performance

DTC P062F

- Control Module Long Term Memory Performance

DTC P0630

- VIN Not Programmed or Mismatched - Engine Control Module (ECM)

DTC P16F3

- Control Module Redundant Memory Performance

DTC P2610

- Control Module Ignition Off Timer Performance

Circuit/System Description

This diagnostic applies to internal microprocessor integrity conditions within the engine control module (ECM). This diagnostic also addresses if

the ECM is not programmed, or is programmed incorrectly.

Conditions for Running the DTC

P0601, P062B, P0630, P16F3