2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 2512

End of test

NO

The measurement values are not OK.Possible cause and remedy

- Check lines between components N73 (EIS [EZS] control unit) and N10/1 (Driver-side SAM control unit with fuse and relay module) and

repair or replace if necessary.

- Fuse and component F34 (Interior fuse box)

Continue with button F2

Possible cause and remedy

- Check component N10/1 (Driver-side SAM control unit with fuse and relay module).

Question

- Continue troubleshooting in control unit N10/1 (Driver-side SAM control unit with fuse and relay module)?

2.1.3.2.1.11. No further information available.

2.1.3.2.1.12. Check power supply at control unit Y3/8n4 (Fully integrated transmission control (VGS) control unit).

Operation number of operation texts and work units or standard texts and flat rates:27-0641Test prerequisite

- Battery voltage is OK.

- Fuse N10/1f46 (Fuse 46) in component N10/1 (Driver-side SAM control unit with fuse and relay module) is o.k.

Test sequence

- Switch off ignition.

- Separate plug connection at transmission.

- Measure voltage in transmission wiring harness using a multimeter.

- Switch on ignition.

Measure direct voltage with multimeter between 5 and 4Specified value

- Voltage [8,5...16,4] V

Question

- Is the measurement value OK?

YES

The measurement value is OK.Further causes

- The diagnosis line is not OK