Friday, April 30, 2021

2010 Cadillac Truck SRX AWD V6-3.0L Page 1738

2010 Cadillac Truck SRX AWD V6-3.0L Page 1738



Diagnostic Overview). Verify the transmission operation performs as indicated in the road test instructions.



9. Review the scan tool snapshot data. Verify the following transmission data parameters display the correct values for each gear range:



* Transmission ISS



* Transmission OSS



* PC Solenoid 2



* TFP Switch 1



10. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing



Note: You must perform the Circuit/System Verification first.



1. Perform the Line Pressure Check (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component



Tests and General Diagnostics/6T70/6T75 - Automatic Transmission/Line Pressure Check). Verify the transmission line pressure gauge is



within the range specified in the Line PC Solenoid Valve Pressure table. Refer to Solenoid Valve Pressure (See: Specifications/Mechanical



Specifications/Automatic Transmission/Transaxle/System Specifications/6T70/6T75 - Automatic Transmission/Solenoid Valve Pressure).



瀚慖f not within the specified ranges, refer to Fluid Pressure High or Low (See: Transmission and Drivetrain/Automatic



Transmission/Transaxle/Testing and Inspection/Symptom Related Diagnostic Procedures/6T70/6T75 - Automatic Transmission/Fluid



Pressure High or Low).



2. Ignition OFF, remove the control solenoid valve assembly. Refer to Control Solenoid Valve and Transmission Control Module Assembly



Replacement (See: Powertrain Management/Transmission Control Systems/Actuators and Solenoids - Transmission and



Drivetrain/Actuators and Solenoids - A/T/Shift Solenoid/Service and Repair).



3. Perform the Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test (See: Transmission and



Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/6T70/6T75 - Automatic



Transmission/Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test). A pressure change should



occur for each solenoid valve.



瀚慖f the control solenoid valve assembly does not pass the performance test, replace the control solenoid valve assembly.



4. Listed in the table below, are conditions for each component that could set DTC P0776 or P0777. Carefully inspect each component for that



condition. Repair or replace as necessary.

No comments:

Post a Comment