Friday, April 30, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 824

2010 Cadillac CTS Sedan AWD V6-3.6L Page 824



* The TFT is 140掳C (284掳F) or greater for 60 seconds or more.



P06AE



The TCM power up temperature is 164掳C (327掳F) or greater for 10 seconds or more.



Action Taken When the DTC Sets



* DTCs P06AC, P06AD, and P06AE are Type C DTCs.



* The TCM allows the vehicle to operate in transmission protection mode.



Conditions for Clearing the DTC



DTCs P06AC, P06AD, and P06AE are Type C DTCs.



Diagnostic Aids



During a road test, the TCM Power-Up temperature should steadily increase to a normal operating temperature, and then stabilize.



Reference Information



Schematic Reference



Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Description and Operation



Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and Operation/Electronic



Component Description)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Ignition ON, clear the DTCs with a scan tool.



2. Operate the vehicle at 64 km/h (40 mph) for 10 minutes. Monitor the TCM Power-Up Temperature parameter and the TCM Temperature



parameter with a scan tool. The TCM Power-Up Temperature parameter and the TCM Temperature parameter should be within 10掳C (18掳F)



of each other.



瀚慖f the TCM Power-Up Temperature parameter is not within the specified value of the TCM Temperature parameter, then replace the Q8



control solenoid valve assembly.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Control solenoid valve assembly replacement. Refer to Control Module References (See: Testing and Inspection/Programming and



Relearning) for replacement, setup, and programming.



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning/Service Fast Learn Adapts) following all transmission related repairs.

No comments:

Post a Comment