2010 Cadillac CTS Sedan AWD V6-3.6L Page 433

2010 Cadillac CTS Sedan AWD V6-3.6L Page 433

Conditions for Running the DTC

The MSM must be powered.

Conditions for Setting the DTC

* If a seat switch circuit is active in one direction and the switch for the opposite direction is pressed, this DTC will set.

* A short to voltage on a switch signal circuit.

Action Taken When the DTC Sets

* A motor output driven in response to a switch considered failed, is deactivated for both directions.

* All memory recall commands are ignored.

* The MSM will respond to any other switch signal that has not set a DTC.

Conditions for Clearing the DTC

* The current DTC will clear and set the code to history, 3 seconds after the fault is no longer present and the ignition is cycled OFF then back

to ACC or RUN.

* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.

Diagnostic Aids

* If one of the switch signal circuits is shorted to voltage, multiple codes will set.

* If a switch is stuck in one direction and the switch is pressed in the opposite direction, a single code will set.

Reference Information

Schematic Reference

Driver Seat Schematics (See: Body and Frame/Seats/Diagrams/Electrical Diagrams/Driver Seat Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Memory Seats Description and Operation (See: Body and Frame/Seats/Description and Operation/Memory Seats)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit

Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, observe all scan tool Memory Seat Module seat switch parameters while pressing and releasing each seat directional switch. The

readings should change between Inactive and Active.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.

2. Verify all scan tool seat switch parameters listed below are Inactive.

* Front Vertical Upward Switch

* Front Vertical Downward Switch

* Rear Vertical Upward Switch

* Rear Vertical Downward Switch

* Horizontal Forward Switch

* Horizontal Rearward Switch

* Recline Forward Switch

* Recline Rearward Switch

瀚慖f not the specified value, test the appropriate signal circuit listed below for a short to voltage. If the circuit tests normal, replace the