2010 Cadillac CTS Sedan AWD V6-3.6L Page 351

2010 Cadillac CTS Sedan AWD V6-3.6L Page 351



Control Module References (See: Testing and Inspection/Programming and Relearning) for radio replacement, setup, and programming



B1325



DTC B1325



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptors



DTC B1325 03



- Device Power Circuit Voltage Below Threshold



DTC B1325 07



- Device Power Circuit Voltage Above Threshold



DTC B1325 4A



- Device Power Circuit Checksum Error - IPC



Diagnostic Fault Information



Circuit/System Description



The following control modules monitor the system voltage through the battery positive (B+) voltage circuits:



* Audio amplifier (AMP)



* HVAC control module (HVAC)



* Instrument panel cluster (IPC)



* Inflatable restraint sensing and diagnostic module (SDM)



* Inflatable restraint front passenger presence system (PPS)



* Object alarm module (RPA)



* Radio



* Remote control door lock receiver (RCDLR EK2)



* Pedestrian impact detection module



* TV antenna module (TVM)



Conditions for Running the DTC



* The voltages supplied to the control modules are in the range of 7-26 V.



* The ignition is ON.



Conditions for Setting the DTC



B1325 03



The control module detects a system voltage less than 9 V for 5 seconds.



B1325 07



The control module detects a system voltage greater than 18 V for 5 seconds.



B1325 4A



The instrument panel cluster (IPC) failed the power on checksum test, either due to low voltage or corrupted memory.



Action Taken When the DTC Sets

Comments

Popular posts from this blog

P179D The redundancy system for DIRECT SELECT was activated. There is a signal above the permissible limit value.

Dremel 4300-9/64 Versatile Corded Rotary Tool Kit with Flex Shaft and Hard Storage Case, High Power & Performance, Variable Speed- Engraver, Etcher, Sander, and Polisher, Ultimate Gift for the DIYER

The BMW M5 Sedan & M5 Touring with BMW M Performance Parts.