Tuesday, February 9, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 1005

2010 Cadillac CTS Sedan AWD V6-3.6L Page 1005



5. Test for 4.8-5.2 V between the signal circuit terminal A and the ground circuit terminal C.



瀚慖f less than the specified range, test the signal circuit for an open/high resistance or a short to ground. If the circuit/connections test



normal, replace the K20 ECM.



瀚慖f greater than the specified range, test the signal circuit for a short to voltage. If the circuit/connections test normal, replace the K20



ECM.



6. Ignition OFF, connect the red lead of the J 38522 to the signal circuit terminal A at the B75B MAF/IAT sensor harness connector. Connect



the battery voltage supply to B+, and ground the black lead.



7. Set the J 38522 Signal switch to 5 V, the Frequency switch to 5K, and the Duty Cycle switch to Normal.



8. Ignition ON, observe the scan tool MAF Sensor frequency parameter. The parameter should be between 4,950-5,025 Hz.



瀚慖f the parameter is not within the specified range, replace the K20 ECM.



9. If all circuits/connections test normal, replace the B75B MAF/IAT sensor.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Mass Airflow Sensor with Intake Air Temperature Sensor Replacement (LLT) (See: Powertrain Management/Computers and Control



Systems/Air Temperature Sensor ( Ambient / Intake )/Service and Repair)Mass Airflow Sensor with Intake Air Temperature Sensor



Replacement (LSA) (See: Powertrain Management/Computers and Control Systems/Air Temperature Sensor ( Ambient / Intake )/Service



and Repair)Mass Airflow Sensor with Intake Air Temperature Sensor Replacement (LF1) (See: Powertrain Management/Computers and



Control Systems/Air Temperature Sensor ( Ambient / Intake )/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for engine control module replacement, setup, and



programming



P0106



DTC P0106 (w/LF1)



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0106



- Manifold Absolute Pressure (MAP) Sensor Performance



Diagnostic Fault Information



Typical Scan Tool Data

No comments:

Post a Comment