Wednesday, February 10, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 367

2010 Cadillac CTS Sedan AWD V6-3.6L Page 367



7. If all circuits test normal, replace the BCM.



Component Testing



Ignition Switch



1. Ignition OFF, disconnect the harness connector at the ignition switch.



2. Verify the resistance between the terminals listed below match for each ignition switch position.



瀚慖f not the specified value, replace the ignition switch.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.



* Ignition and Start Switch Replacement (See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition



Switch/Service and Repair/Ignition and Start Switch Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming



Lighting



DTC B1395



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of the diagnostic category.



DTC Descriptors



DTC B1395 03



- Device Voltage Reference Output 1 Circuit Voltage Below Threshold



DTC B1395 07



- Device Voltage Reference Output 1 Circuit Voltage Above Threshold



Diagnostic Fault Information



Circuit/System Description



The instrument panel (I/P) lamp dimmer switch is used to increase and decrease the brightness of the interior backlighting components. The I/P

No comments:

Post a Comment