2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2473

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 2473

瀚慖f not within the specified range, test the circuit for an open/high resistance. If the circuit tests normal, replace the ECM.

7. If all circuits and connections test normal, replace the throttle body assembly.

Repair Instructions

* Throttle Body Assembly Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and

Repair/Removal and Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for Engine Control Module replacement,

programming, and setup

Repair Verification

1. Install any components that have been removed or replaced during diagnosis.

2. Perform any adjustments, programming or setup procedures that are required when a component is removed or replaced.

3. Clear the DTCs with a scan tool.

4. Turn OFF the ignition for 60 s.

Note: If the Throttle Sweep Test is not available on the scan tool, use the accelerator to perform the test. Refer to Diagnostic Aids for further

details.

5. Perform the Throttle Sweep Test while observing the TAC Motor parameter with a scan tool. The TAC Motor parameter should display

Enabled while the Throttle Sweep Test is in progress.

6. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in

order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List -

Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) and perform the appropriate diagnostic

procedure.

P2119

DTC P1516, P2101, P2119, or P2176

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P1516

- Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance

DTC P2101

- Throttle Actuator Position Performance

DTC P2119

- Throttle Closed Position Performance

DTC P2176

- Minimum Throttle Position Not Learned

Diagnostic Fault Information

Circuit/System Description

The engine control module (ECM) controls the throttle valve by applying a varying voltage to the control circuits of the throttle actuator control

(TAC) motor. The ECM monitors the duty cycle that is required to actuate the throttle valve. The ECM monitors the throttle position (TP) sensors 1

and 2 to determine the actual throttle valve position.