2010 Cadillac Truck SRX AWD V6-3.0L Page 819

2010 Cadillac Truck SRX AWD V6-3.0L Page 819

DTC Descriptor

DTC C0406 0B

- Transfer Case Solenoid Valve Control Circuit High Current

Diagnostic Fault Information

Circuit/System Description

The rear drive clutch solenoid valve is internal to the torque transfer device housing. The rear differential clutch control module supplies battery

voltage to the control circuit and ground to the low reference circuit of the solenoid valve. The solenoid valve is controlled by a pulse width

modulation (PWM) signal. The solenoid valve controls the hydraulic pressure to the clutch package of the torque transfer device. The locking level

of the torque transfer device depends on the engagement of the clutch package.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

* The rear differential clutch control module detects a short to ground on the control circuit of the rear drive clutch solenoid valve.

* The rear differential clutch control module detects a current more than 11 A on the control circuit of the rear drive clutch solenoid valve.

Action Taken When the DTC Sets

One or more of the following actions may occur:

* All-wheel drive (AWD) is disabled.

* Service Rear Axle is displayed on the driver information center.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.

* The DTC is not detected in 40 consecutive ignition cycles.

Reference Information

Schematic Reference

Rear Axle Schematics (See: Transmission and Drivetrain/Differential Assembly/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)

Description and Operation

Rear Drive Axle Description and Operation (See: Transmission and Drivetrain/Differential Assembly/Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Engine running, observe the scan tool Rear Drive Clutch Status parameter. The scan tool should display TEMPORARILY LIMITED when