Thursday, September 3, 2020

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1643

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1643



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning/Service Fast Learn Adapts) following all transmission related repairs.



* Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement,



setup, or programming.



P0776



DTC P0776 or P0777



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0776



- Clutch Pressure Control (PC) Solenoid 2 - Stuck Off



DTC P0777



- Clutch Pressure Control (PC) Solenoid 2 - Stuck On



Circuit/System Description



The clutch pressure control (PC) solenoid 2 is part of the control solenoid valve assembly, which has no serviceable parts. The PC solenoid 2



regulates transmission fluid pressure to the 3-5-Reverse clutch regulator valve which controls pressure to the 3-5-Reverse clutch. The TCM



calculates gear ratio based on the RPM signals from the input speed sensor (ISS) and the output speed sensor (OSS). The TCM compares the



expected transmission gear ratio to the calculated gear ratio for each commanded gear.



Conditions for Running the DTC



P0776



* DTCs P0121, P0122, P0123, P0716, P0717, P0722, P0723, or P182E are not set.



* Ignition voltage is 8.6 volts or greater.



* Engine speed is 500 RPM or greater for 5 seconds.



* Transmission fluid temperature (TFT) is equal to or greater than 0掳C (32掳F).



* High side driver is enabled.



* Average driven wheel speed is 80 RPM or more.



* Side to side average wheel speed between driven and non-driven wheel is 150 RPM or less for 6 seconds.



* The transmission input shaft speed is greater than 60 RPM.



* PC solenoid 2 is commanded ON.



* 3rd or 5th gear ratio has been achieved.



P0777



* DTCs P0716, P0717, P0722, P0723, or P182E are not set.



* Transmission fluid temperature (TFT) is equal to or greater than 0掳C (32掳F).



* Ignition voltage is 8.6 volts or greater.



* Engine speed is 500 RPM or greater for 5 seconds.



* High side driver is enabled.



* The transmission input and output shaft speed is greater than 200 RPM.



* PC solenoid 2 is commanded OFF.



Conditions for Setting the DTC



P0776



The TCM detects an incorrect on-coming clutch gear ratio, or flare, when the 3-5-R clutch is commanded ON for 2.25 seconds and the transmission



input shaft speed is 60-100 RPM or greater from the anticipated input shaft speed.

No comments:

Post a Comment