2010 Cadillac CTS Sedan AWD V6-3.0L Page 1562

2010 Cadillac CTS Sedan AWD V6-3.0L Page 1562

3. Connect a test lamp between the control circuit terminal 13 and the ignition circuit terminal 20.

4. Command the MIL ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.

瀚慖f the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the K20 ECM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace

the K20 ECM.

5. If all circuits test normal, replace the P16 instrument cluster.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM and instrument cluster replacement, setup, and

programming

P0651

DTC P0641, P0651, P0697, or P06A3 (ECM, LF1)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0641

- 5 V Reference 1 Circuit

DTC P0651

- 5 V Reference 2 Circuit

DTC P0697

- 5 V Reference 3 Circuit

DTC P06A3

- 5 V Reference 4 Circuit

Circuit/System Description

The engine control module (ECM) has 4 5 V reference circuits. The ECM provides the 5 V reference to various sensors. Each reference circuit

provides a 5 V reference for more than one sensor. An open, short to ground, or short voltage on one of the 5 V reference circuits can affect all the

components connected to that 5 V reference circuit. The ECM monitors the voltage on the 5 V reference circuits.

Conditions for Running the DTC

DTCs P0641, P0651, P0697, P06A3 run continuously when the ignition is ON.

Conditions for Setting the DTC

The 5 V reference circuit voltage is greater or less than a predetermined threshold.

Action Taken When the DTC Sets

DTCs P0641, P0651, P0697, and P06A3 are Type A DTCs.

Conditions for Clearing the DTC

DTCs P0641, P0651, P0697, and P06A3 are Type A DTCs.