Wednesday, November 20, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 356

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 356

瀚慖f the module will not reprogram, replace the HVAC control module that set the DTC.

2. With a scan tool, clear the DTC.

3. Ignition OFF.

4. Wait 60 seconds, then recheck for DTCs. DTC B1023 should not set.

瀚慖f DTC B1023 sets, replace the module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning)for control module replacement, setup, and programming

HVAC - Manual

DTC B1023

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC B1023 05

- Integral Switch Performance Short to Ground

DTC B1023 06

- Integral Switch Performance Short to Battery or Open

DTC B1023 61

- Integral Switch Performance Signal Invalid

Circuit/System Description

This DTC may be set by an open or shorted 5 volt reference circuit to the auxiliary HVAC control module or an internal fault inside the HVAC

control module for a stuck or shorted control button.

Conditions for Running the DTC

Battery voltage is between 9-16 volts and data link communications operate normally.

Conditions for Setting the DTC

The HVAC control module has internal fault inside the HVAC control module for a stuck or shorted control button or shorted 5 volt reference

circuit.

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.

* A history DTC clears when the module ignition cycle counter reaches the reset threshold, without a repeat of the malfunction.

Reference Information

Schematic Reference

HVAC Schematics (See: Heating and Air Conditioning/Diagrams/Electrical Diagrams/HVAC - Manual)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

* Air Temperature Description and Operation (See: Heating and Air Conditioning/Description and Operation/HVAC - Manual/Air

Temperature Description and Operation)Air Temperature Description and Operation

No comments:

Post a Comment