Sunday, November 17, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 871

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 871

* Terminal 13

* Terminal 38

瀚慖f the test lamp does not illuminate, test the B+ circuits for a short to ground or an open/high resistance.

4. If all circuits test normal, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming

C0242

DTC C0242 or P0856

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C0242 00

- Engine Control Module (ECM) Indicated TCS Malfunction

DTC P0856

- Traction Control Torque Request Circuit

Circuit/System Description

The electronic brake control module (EBCM) and the engine control module (ECM) simultaneously control the traction control. The EBCM sends

a serial data message to the ECM requesting torque reduction. When certain ECM DTCs are set, the ECM will not be able to perform the torque

reduction for traction control. A serial data message is sent to the EBCM indicating that traction control is not allowed.

Conditions for Running the DTC

Engine running.

Conditions for Setting the DTC

The ECM detects a fault that prevents it from performing a traction control function and sends a serial data message to the EBCM indicating that

torque reduction is not allowed.

Action Taken When the DTC Sets

The EBCM sends a serial data message to illuminate the appropriate warning/indicator message

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

No comments:

Post a Comment