2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 971

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 971

2. Test for.7-3.3 ohm between the control terminal A and the low control terminal B of the suspension damper.

瀚慖f not within the specified range, replace the suspension damper.

Repair Instructions

* Shock Absorber Replacement (1500) (See: Steering and Suspension/Suspension/Suspension Strut / Shock Absorber/Service and

Repair/Rear Suspension Shock Absorber/Shock Absorber Replacement (1500))Shock Absorber Replacement (2500) (See: Steering and

Suspension/Suspension/Suspension Strut / Shock Absorber/Service and Repair/Rear Suspension Shock Absorber/Shock Absorber

Replacement (2500))

* Suspension Position Calibration (With Z95) (See: Steering and Suspension/Suspension/Suspension Control ( Automatic - Electronic

)/Service and Repair/Suspension Position Calibration (With Z95))Suspension Position Calibration (Without Z95) (See: Steering and

Suspension/Suspension/Suspension Control ( Automatic - Electronic )/Service and Repair/Suspension Position Calibration (Without Z95))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for ESCM replacement, setup, and programming

Repair Verification

1. Install any components or connectors that have been removed or replaced during diagnosis.

2. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.

3. Clear the DTCs.

4. Use the scan tool Diagnostic Counter Reset output control function to bypass the 3 consecutive ignition cycle requirement for setting a DTC.

This will ensure that if a DTC was to be reset during the repair verification process, it will be displayed on the scan tool.

5. Turn OFF the ignition for 60 seconds.

6. Turn ON the ignition.

7. If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if appropriate,

in order to verify the DTC does not reset. If the DTC resets or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List -

Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) and perform the appropriate diagnostic

procedure

C0580

DTC C0575, C0580, C0585, or C0590

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C0575 01

- Left Front Actuator Circuit - Short To Battery

DTC C0575 02

- Left Front Actuator Circuit - Short To Ground

DTC C0575 04

- Left Front Actuator Circuit - Open Circuit

DTC C0580 01

- Right Front Actuator Circuit - Short To Battery

DTC C0580 02

- Right Front Actuator Circuit - Short To Ground

DTC C0580 04

- Right Front Actuator Circuit - Open Circuit

DTC C0585 01

- Left Rear Actuator Circuit - Short To Battery

DTC C0585 02

- Left Rear Actuator Circuit - Short To Ground

DTC C0585 04

- Left Rear Actuator Circuit - Open Circuit