2010 Mercedes Benz C 300 (204.054) V6-3.0L (272.947) Page 1355

YES

The measurement value is OK.End of test

NO

The measurement value is not OK.Possible cause and remedy

- Line from component N10/1 (Front SAM control unit with fuse and relay module) to component N15/6 (Sprintshift control module)

End of test

NO

The measurement value is not OK.Possible cause and remedy

- Check fuse "f63" (voltage supply from control unit ASG) in component N10/1 (Front SAM control unit with fuse and relay module).

- Test cables

End of test

1.1.3.2.1.7. Check power supply at control unit N47-5 (ESP, SPS [PML] and BAS control unit).

Test 1.1.3.2.1.7.1: Test voltage of terminal 87 at control unit N47-5 (ESP, SPS [PML] and BAS control unit).

Test 1.1.3.2.1.7.2: Test of cable for voltage supply

Test 1.1.3.2.1.7.3: Test procedure ground cable

1.1.3.2.1.7.1. Test voltage of terminal 87 at control unit N47-5 (ESP, SPS [PML] and BAS control unit).

Test prerequisite

- Battery voltage is OK.

Test sequence

- Switch off ignition.

- Connect socket box.

- Switch on ignition.

- Measure direct voltage with multimeter between sockets (2.23) 57 and (2.14) 48 of the 126-pole socket box tester.

Specified value

- [11...14 V]

Question

- Is the measurement value OK?