2020 BMW 128i Coupe (E82) L6-3.0L (N51) Diagnostic Trouble Codes ( DTC ): Service instruction
none
2E68 - P0328 (DME)
2E68 - P0328
Information saved in
DME
Fault code
2E68 - P0328
Fault text
Knock-sensor signal 1
Fault description
Knock Sensor 1 Circuit High (Bank 1 or Single Sensor)
Condition for fault identification
Test condition:
Knock sensor signal monitor
Vehicle road operation at >2800 1 rpm (current data status, tends toward >2560 rpm) and air mass > 180 mg/unit. It is not possible to clear fault by switching ignition terminals. Compliance with the activation conditions and absence of malfunction extending over several seconds are required before fault code can be cleard.
Terminal condition: Terminal 15, engine on Voltage condition:
Voltage in onboard electrical system > 10 V
Condition for fault memory entry
Yes, by event counter. If knock sensor signal remains below threshold (differential knock signal > 4.8 V) for 1...3 sec. fault code is stored
Action in service
Check knock sensor connection to verify that it is tight.
Check wire connecting knock sensor 1 and engine- management control module
Check for connection between knock sensor 1 and ground or positive
Replace knock sensor
Fault effect and breakdown warning
Driver information
Warning light:
No warning message. (No closed-loop knock control available. Power loss, as engine reverts to operation in safe range.)
No comments:
Post a Comment