Wednesday, February 20, 2019

Body - Buzzing Wind Noise From A-Pillar/Mirror Area

2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Technical Service Bulletin # 11-078 Date: 110811



Body - Buzzing Wind Noise From A-Pillar/Mirror Area



Classification: BT11-029



Reference: NTB11-078



Date: August 11, 2011



2008-2012 ALTIMA COUPE; DOOR WEATHER STRIP NOISE



APPLIED VEHICLE(S): All 2008-2012 Altima Coupe



IF YOU CONFIRM



A loud "buzzing type" wind noise from the base of either A-Pillar (RH or LH) and above mirror(s), at highway speeds.



ACTIONS



Follow Service Procedure to correct Weather Strip gap condition.



NOTE:



Replacement of the door weather strip is not needed as part of this repair.



CLAIMS INFORMATION



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 222



SERVICE PROCEDURE



1. Clean surface of A-pillar Weather Strip molded area, indicated in Figure 1, with water and then dry.



NOTE:



Figure 5 gives cross section of area requiring cleaning, where EPT foam from the Nissan Squeak and Rattle Kit will be placed.



2. Cut a strip of EPT foam to size 5x5x40mm. Add into the Weather Strip, into the outer face of the lip with steps "a" through "d" below.



a. Confirm molded area is clean; mainly the outer face of the lip and apply generic primer:



b. Remove liner from EPT foam.



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 223



C. Add EPT foam into outside of the lip and make sure adhesion is complete.



2010 Nissan-Datsun Altima L4-2.5L (QR25DE) Hybrid Page 224



NOTE:



EPT foam must be added 10mm forward of the mold joint line. See figures 6 and 7.



d. Confirm that EPT is not visible.



NOTE:



Figures 8 and 9 show examples of correct installation.



3. Test drive the vehicle to make sure the "buzzing type" wind noise has been resolved.

No comments:

Post a Comment