YES
The actual value is okay.Further possible causes of fault
- Unmetered air
- Signal wire
- B2/5 (Hot film mass air flow sensor)
End of test
NO
The measurement value is not OK.Possible cause and remedy
- N10/1f43 (Fuse 43)
- Cable for voltage supply
End of test
2182
The air mass measured by the hot film MAF sensor is too high. / The cycle duration of the HFM signal is too short. (P0101)
Possible cause:
- B2/5 (Hot film mass air flow sensor)
Affected functions:
- Engine diagnosis
-------------------------------------------------
Test 1: Check component B2/5 (Hot film mass air flow sensor).
1. Check component B2/5 (Hot film mass air flow sensor).
Test 1.1: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.
Test 1.2: Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine speed greater than 3500 rpm.
Test 1.3: Check reference signal of component B2/5 (Hot film mass air flow sensor).
Test 1.4: Check power supply of component B2/5 (Hot film mass air flow sensor).
1.1. Check signal of component B2/5 (Hot film mass air flow sensor) via actual value with engine OFF.
No comments:
Post a Comment