2010 Land Rover LR2 (LF) L6-3.2L Technical Service Bulletin # TECLTB00495 Date: 121112
Engine Controls - MIL ON With DTC P2097 And P2099 Stored
TECHNICAL BULLETIN
LTB00495NAS1
21-NOV-12
SECTION: 303-14A
Engine MIL Illuminated with DTC P2097 and P2099 Stored
AFFECTED VEHICLE RANGE:
VIN: AH148520-CH319914
LR2 (LF)
Model Year: 2010-2012
CONDITION SUMMARY:
Situation:
The engine Malfunction Indicator Lamp (MIL) may be illuminated with Diagnostic Trouble Codes (DTC) P2097 and P2099 stored in the Engine
Control Module (ECM).
Cause:
This may be caused by software strategy within the ECM.
Action:
In the event of a customer concern of the above, refer to the Repair Procedure outlined.
PARTS:
No parts required
TOOLS:
IDS with latest IDS-DVD and Calibration File; first available on IDS-DVD131.09 v.120
Land Rover-approved Midtronics Vehicle Power Supply
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.
Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
REPAIR PROCEDURE
CAUTION:
Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the
vehicle.
CAUTION:
A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module
programming.
1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.
2. Turn ignition 'ON' (engine not running).
3. NOTE: IDS must be loaded with IDS-DVD131.09 v.120 or later.
Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
4. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
5. From the Session Type selection screen, choose 'Diagnosis'.
2010 Land Rover LR2 (LF) L6-3.2L Page 2
6. Select the 'Selected Symptoms' tab, and then select the following:
^ Electrical > Instruments > Warning lamps > Engine malfunction lamp > Lamp Illuminated
7. Select 'continue'.
8. Select the 'Recommendations' tab.
9. NOTE: In the event a pop-up requests Emissions level, select Federal.
From the Recommendations tab, select 'Run' to perform the Configure existing module - Powertrain control module' application.
^ Follow all on-screen instructions to complete this task.
10. Exit the current session.
11. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.
No comments:
Post a Comment