Saturday, May 8, 2021

2010 Cadillac Truck SRX FWD V6-3.0L Page 695

2010 Cadillac Truck SRX FWD V6-3.0L Page 695



3. Test for infinite resistance between the following terminals:



* 30 and 86



* 30 and 87



* 30 and 85



* 85 and 87



瀚慖f not the specified value, replace the relay.



4. Test for less than 5 ohm between terminals 30 and 87A.



瀚慖f greater than the specified range, replace the relay.



5. Install a 10 A fused jumper wire between relay terminal 85 and 12 volts. Install a jumper wire between relay terminal 86 and ground. Test for



less than 5 ohm between terminals 30 and 87.



瀚慖f greater than the specified range, replace the relay.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup, and programming



* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay



Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power



Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))



B3806



DTC B3806



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC B3806 00



- High Beam and Headlamp Flash Select Circuit Malfunction



Diagnostic Fault Information



Circuit/System Description



The BCM monitors the voltage level within the high beam signal circuit and the flash to pass signal circuit. When the turn signal/multifunction



switch is moved to the high beam position or to the flash to pass position, the voltage within the appropriate signal circuit drops to less than 1 V.



The BCM will detect the voltage drop and will command the headlamp high beams to turn ON or OFF.



Conditions for Running the DTC



Battery voltage must be between 9-16 V.



Conditions for Setting the DTC

No comments:

Post a Comment