Sunday, May 9, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 555

2010 Cadillac CTS Sedan AWD V6-3.6L Page 555



Without RPO Y41



With each press of a keyless entry transmitter button, a message containing the current battery state of the transmitter is sent to the remote control



door lock receiver (RCDLR) along with the commanded keyless entry function.



With RPO Y41



When starting the vehicle, a message containing the current battery state of the transmitter is sent to the remote control door lock receiver



(RCDLR).



Conditions for Running the DTC



Without RPO Y41



A keyless transmitter button is pressed.



With RPO Y41



Ignition ON.



Conditions for Setting the DTC



The DTC sets after 3 consecutive low battery signals from the same programmed transmitter.



Action Taken When the DTC Sets



The keyless entry system is inoperative.



Conditions for Clearing the DTC



The DTC is cleared when a normal transmitter voltage signal is received from the programmed transmitter that set the DTC.



Reference Information



Schematic Reference



Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry



Transmitter/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views)



Description and Operation



Keyless Entry System Description and Operation (with RPO Y41) (See: Accessories and Optional Equipment/Antitheft and Alarm



Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (with RPO Y41))Keyless Entry System



Description and Operation (without RPO Y41) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless



Entry/Description and Operation/Keyless Entry System Description and Operation (without RPO Y41))



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/Circuit



Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/Wiring Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



Verify none of the following DTCs are set:



* DTC B3109



* DTC B3110



* DTC B3111



* DTC B3112



If any of the DTCs are set, replace the battery in the appropriate keyless entry transmitter. Operate the transmitter 3 consecutive times. If the DTC



resets, replace the keyless entry transmitter.

No comments:

Post a Comment