Sunday, May 9, 2021

2010 Cadillac CTS Sedan AWD V6-3.6L Page 591

2010 Cadillac CTS Sedan AWD V6-3.6L Page 591



DIC Switch parameters, except the DIC Fuel Info. parameter are Active.



瀚慖f any are not Active, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the IPC.



6. Ignition ON, install a 3A fused jumper wire between the signal circuit terminal 3 and ground. Verify the scan tool DIC Fuel Info. parameter



is Active.



瀚慖f not Active, test the signal circuit for a short to voltage or and open/high resistance. If the circuit tests normal, replace the IPC.



7. If all the circuits test normal, test or replace the DIC switch.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Driver Information Display Switch Replacement (See: Accessories and Optional Equipment/Driver / Vehicle Information Display



Switch/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for the IPC replacement, setup, and programming



B3588



DTC B3588



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC B3588 02



- Rear Fog Lamp Switch Circuit Short to Ground



Diagnostic Fault Information



Circuit/System Description



The rear fog lamp relay is supplied with battery voltage at all times from the REAR FOG fuse located in the rear fuse block. The rear fog lamp



switch signal circuit is grounded momentarily by pressing the rear fog lamp switch. The body control module (BCM) energizes the rear fog lamp



relay by applying ground to the rear fog lamp relay control circuit. When the rear fog lamp relay is energized, the relay switch contacts close and



battery voltage is applied through the REAR FOG fuse to the rear fog lamp supply voltage circuit which illuminates the rear fog lamps.



Conditions for Running the DTC



Battery voltage must be between 9-16 V.



Conditions for Setting the DTC



The BCM detects a short to ground in the rear fog lamp switch signal circuit.



Actions Taken When the DTC Sets



The rear fog lamps will not operate when the park lamps are ON.

No comments:

Post a Comment