2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 388

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 388

Conditions for Running the DTC

The radio is ON.

Conditions for Setting the DTC

Set by Radio

The radio sets a current status for this DTC when a short to ground, short to voltage or an open is detected on any of the speaker channel outputs

from the radio.

Set by Bose Amplifier

The DTC will not set during normal amplifier operation. The vehicle must have the ignition OFF for several hours and the fault must be present

during amplifier power-up.

DTC B1025 01, B1035 01, B1045 01, B1055 01, B1065 01, B1075 01, B1085 01, B1095 01

A short to voltage is detected on the specified (+) or (-) signal circuit

DTC B1025 02, B1035 02, B1045 02, B1055 02, B1065 02, B1075 02, B1085 02, B1095 02

A short to ground is detected on the specified (+) or (-) signal circuit

DTC B1025 04, B1035 04, B1045 04, B1055 04, B1065 04, B1075 04, B1085 04, B1095 04

An open is detected on the specified (+) or (-) signal circuit

Action Taken When the DTC Sets

No sound is present from one or more of the speakers.

Conditions for Clearing the DTC

Set by Radio

The fault condition becomes history if not present for 0.25 seconds.

Set by Bose Amplifier

The fault condition becomes history after the vehicle ignition has been OFF for several hours and then the ignition turns ON.

Diagnostic Aids

Speakers located in the front A-pillar are connected to the same channel as the speaker in the door. A DTC will only set after the amplifier only on

up-level radios.

Reference Information

Schematic Reference

Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information