2010 Cadillac Truck Escalade RWD V8-6.2L Page 1644

2010 Cadillac Truck Escalade RWD V8-6.2L Page 1644

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0133

- HO2S Slow Response Bank 1 Sensor 1

DTC P013A

- HO2S Slow Response Rich to Lean Bank 1 Sensor 2

DTC P013B

- HO2S Slow Response Lean to Rich Bank 1 Sensor 2

DTC P013C

- HO2S Slow Response Rich to Lean Bank 2 Sensor 2

DTC P013D

- HO2S Slow Response Lean to Rich Bank 2 Sensor 2

DTC P013E

- HO2S Delayed Response Rich to Lean Bank 1 Sensor 2

DTC P013F

- HO2S Delayed Response Lean to Rich Bank 1 Sensor 2

DTC P014A

- HO2S Delayed Response Rich to Lean Bank 2 Sensor 2

DTC P014B

- HO2S Delayed Response Lean to Rich Bank 2 Sensor 2

DTC P0153

- HO2S Slow Response Bank 2 Sensor 1

DTC P1133

- HO2S Insufficient Switching Bank 1 Sensor 1

DTC P1153

- HO2S Insufficient Switching Bank 2 Sensor 1

Diagnostic Fault Information

Circuit/System Description

The heated oxygen sensors (HO2S) are used for fuel control and catalyst monitoring. Each HO2S compares the oxygen content of the surrounding

air with the oxygen content of the exhaust stream. When the engine is started, the control module operates in an Open Loop mode, ignoring the

HO2S signal voltage while calculating the air-to-fuel ratio. While the engine runs, the HO2S heats up and begins to generate a voltage within a

range of 0-1,275 mV. Once sufficient HO2S voltage fluctuation is observed by the control module, Closed Loop is entered. The control module