Wednesday, January 15, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1433

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1433



瀚慖f less than the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace



the K9 BCM.



4. Ignition OFF, disconnect the X1 harness connector at the K9 BCM.



5. Test for infinite resistance between the signal circuit terminal 3 and ground.



瀚慖f less than the specified value, test the signal circuit for a short to ground.



6. If all circuits test normal, test or replace the S70L steering wheel control switch-left.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Cruise Control Switch Replacement (See: Cruise Control/Cruise Control Switch/Service and Repair)



* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, setup, and programming



P0572



DTC P0572 or P0573



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptors



DTC P0572



- Brake Switch Circuit 1 Low Voltage



DTC P0573



- Brake Switch Circuit 1 High Voltage



Diagnostic Fault Information



Circuit/System Description



The stop lamp switch signal circuit is a B+ input from the body control module (BCM) to the engine control module (ECM). The ECM monitors



the stop lamp switch circuit to detect when the brake pedal has been applied. The BCM monitors the brake pedal position sensor to determine when



the brake pedal is applied. When the brake pedal is applied, the BCM supplies B+ on the stop lamp switch signal circuit and also sends a serial data



message to the ECM indicating that the brake pedal has been applied.



Conditions for Running the DTC



* The engine is running.



* Battery voltage is greater than 11.5 V.



Conditions for Setting the DTC



P0572



This DTC will set when the ECM detects a short to ground or an open on the discrete brake signal circuit when the serial data message from the



BCM indicates the brakes are applied. This diagnostic will run when the serial data message and the voltage signal on the brake switch signal



circuit do not match for 8 out 10 times, and the condition is present for greater than 2 seconds.



P0573



This DTC will set when the ECM detects a short to voltage on the discrete brake signal circuit when the serial data message from the BCM



indicates the brakes are NOT applied. This diagnostic will run when the serial data message and the voltage signal on the brake switch signal circuit



do not match for 8 out 10 times, and the condition is present for greater than 2 seconds.

No comments:

Post a Comment