Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLTB00332 Date: 110311

Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLTB00332 Date: 110311

Audio System - Unable To Load/Eject CD

No: LTB00332 (ISSUE 1)

11 MAR 2011

SECTION: 415

Unable to Load / Eject CD

AFFECTED VEHICLE RANGE:

LR4 (LA)

VIN: AA510742 - BA564056

Model Year: 2010 - 2011

Range Rover Sport (LS)

VIN: AA212147 - BA277827

Model Year: 2010 - 2011

CONDITION SUMMARY:

Situation:

The CD player may not load or eject a CD. This may be caused by a software error.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to update the Audio front control module software.

PARTS:

No parts necessary

TOOLS:

IDS with latest IDS-DVD and Calibration File; first available on IDS-DVD123_V7.06 Calibration File 53 Land Rover-approved Midtronics Vehicle

Power Supply

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.

Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal Warranty policies and procedures apply

REPAIR PROCEDURE

UPDATE THE AUDIO FRONT CONTROL MODULE SOFTWARE

2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 99

CAUTION:

Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the

vehicle.

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module

programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

2. Turn ignition ON (engine not running).

NOTE:

IDS must be loaded with IDS-DVD123_V7.06 or later and Calibration File 53 or later.

3. Connect the IDS to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

4. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

5. From the Session Type selection screen, choose 'Diagnosis'.

6. Select the Selected Symptoms tab, and then select:

^ Electrical > information and entertainment system > Entertainment system > Audio > CD or DVD load or eject inoperative

7. Select 'continue'.

8. Select the Recommendations tab.

9. From the Recommendations tab, select Run to configure the Audio front control module

^ Follow all on-screen instructions to complete this task.

10. Exit the current session.

11. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.