Body - Side Wall Seam Above Rear Lamps Cracked

Body - Side Wall Seam Above Rear Lamps Cracked

Side wall seam above rear lamps cracked

Topic number LI64.30-N-048760

Version 1

Design group 64.30 Corner paneling

Date 02-01-2010

Validity Sprinter model designation 906.6##

Reason for change

Reason for block

Complaint:

1. The PVC sealing seam above the rear lamps is cracked.

2. Visible corrosion above the rear lamps at the transitions from the D-pillars to the rear side walls.

Cause:

The sealing seams were applied up to the area above the rear lamps and may have been penetrated by moisture.

2010 Mercedes Benz Truck Sprinter 3500 Cab (906.153) V6-3.0L DSL Turbo (642.898)

Page 63

Remedy:

Swift implementation of the necessary repair work prevents subsequent damage at a later date and can be performed without damage to the

paintwork. For this reason we would ask you to perform the necessary repair work as quickly

as possible!

Remove/install the rear lamps on both sides of the vehicle. Remove the sealing seams above the rear lamps from the joint to a height of approx. 20

cm. The adjacent paint surfaces should be masked with two layers of fabric tape to prevent

damage. Any existing corrosion features in the joints must be eliminated if necessary in accordance with MB guidelines. To do this, use primer

and filler materials from the paint partners approved in the warranty systems. Then remove the fabric tape and re-mask the exposed joints with

masking tape. Then prime the joints. Next, renew the masking tape again and apply a new sealing seam to the joints. Mold the new sealing seams and

extend then into the recesses for the rear lamps (see Fig. 1).

2010 Mercedes Benz Truck Sprinter 3500 Cab (906.153) V6-3.0L DSL Turbo (642.898)

Page 64

A corresponding WIS document is being prepared.