2010 Cadillac Truck SRX FWD V6-3.0L Technical Service Bulletin # 03-00-89-008F Date: 120424
Body - Metal Body Panel Corrosion Protection
INFORMATION
Bulletin No.: 03-00-89-008F
Date: April 24, 2012
Subject: Corrosion Protection for Metal Panels with Dealer Installed Accessories Fastened by Drilled Holes
Models:
2013 and Prior GM Passenger Cars and Trucks
Supercede:
This bulletin is being revised to update the model years. Please discard Corporate Bulletin Number 03-00-89-008E (Section 00 - General
Information).
Corrosion Concerns
Frequently, dealer installed accessories, whether aftermarket or GM-approved, may require drilling holes into the body panels or supports to
complete installation. Whenever you drill into a metal surface, the corrosion resistance of that panel is compromised. Testing was conducted to
determine the best method used to protect the fastener-to-panel mounting holes from future corrosion. Several commercially available sealers and
coatings were evaluated.
Recommendations
In all cases, GM Vehicle Care Super Lube(R) with PTFE performed the best at preventing corrosion in fastener to panel interface holes and is now
the official GM recommended product as shown in the above illustration. It is recommended to apply the GM Vehicle Care Super Lube(R) with
PTFE to any hole and fastener before installing the fastener into the drilled attaching hole or inside the metal panel.
Important
GM Vehicle Care Super Lube(R) with PTFE is the only product recommended and required by GM for the corrosion protection of metal
panels where fasteners will be added to metal panels.
2010 Cadillac Truck SRX FWD V6-3.0L Page 57
No comments:
Post a Comment