Sunday, March 20, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 816

2010 Cadillac Truck SRX FWD V6-3.0L Page 816



C0402 04



The ignition is ON.



C0402 61



* Engine running.



* When requested torque is less than 25 Nm (18 lb ft) and the calculated temperature is in the range of 0-90掳C (32-194掳F).



Conditions for Setting the DTC



C0402 02



Voltage is applied to the rear drive clutch solenoid valve. An error is detected if the current is greater than the current which corresponds to less



than 2 ohm resistance in the solenoid valve.



C0402 04



The measured current deviates from the nominal value with more than 200 mA for more than 100 ms.



C0402 42 and C0402 43



The solenoid valve calibration values stored in the rear differential clutch control module EEPROM are invalid or out of range.



C0402 4B



There are no solenoid valve calibration values stored in the differential clutch control module EEPROM.



C0402 61



An error is detected if the solenoid valve is not engaging adequately over a predetermined test sequence.



Action Taken When the DTC Sets



C0402 02, C0402 04 and C0402 61



One or more of the following actions may occur:



* All-wheel drive (AWD) is disabled.



* Service Rear Axle is displayed on the driver information center.



C0402 42, C0402 43 and C0402 4B



An error record is stored in the rear differential clutch control module. No action will be performed.



Conditions for Clearing the DTC



* The condition for setting the DTC is no longer present.



* The DTC is not detected in 40 consecutive ignition cycles.



Reference Information



Schematic Reference



Rear Axle Schematics (See: Transmission and Drivetrain/Differential Assembly/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Rear Drive Axle Description and Operation (See: Transmission and Drivetrain/Differential Assembly/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)

No comments:

Post a Comment