Monday, March 21, 2022

2010 Cadillac Truck SRX FWD V6-3.0L Page 2059

2010 Cadillac Truck SRX FWD V6-3.0L Page 2059



Circuit/System Verification



1. Engine running, accessories OFF, measure and record the battery voltage at the battery terminals. The voltage should be between 12.6-15.0



volts.



瀚慖f the voltage is not within the specified range, or the charge indicator light is ON, refer to Charging System Test (See: Starting and



Charging/Testing and Inspection/Component Tests and General Diagnostics/Charging System Test).



2. Observe the scan tool TCM Ignition Voltage parameter. The reading should be between 12.6-15.0 volts.



3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the



conditions that you observed from the Freeze Frame/Failure Records data.



Circuit/System Testing



1. Ignition OFF, disconnect the 20-way harness connector at the transmission.



2. Connect the DT-47825-20 to the 20-way transmission harness connector.



3. Test for less than 10 ohms between the ground circuit terminals listed below and ground.



* Terminal 1



* Terminal 18



瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.



4. Ignition ON, verify that a test lamp illuminates between the ignition and B+ circuit terminals listed below and ground.



* Terminal 10



* Terminal 13



* Terminal 15



瀚慖f the test lamp does not illuminate, test the affected ignition or B+ circuit for a short to ground or an open/high resistance.



5. If all circuits test normal, replace the control solenoid valve assembly.



Repair Instructions



Important:



* Perform the Service Fast Learn Adapts (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and



Inspection/Programming and Relearning) following all transmission related repairs.



* Before replacing the TCM, perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See:



Transmission and Drivetrain/Automatic Transmission/Transaxle/Testing and Inspection/Component Tests and General



Diagnostics/6T70/6T75 - Automatic Transmission/Control Solenoid Valve and Transmission Control Module Assembly Inspection).



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



Control Module References (See: Testing and Inspection/Programming and Relearning) for control solenoid valve assembly replacement, setup,



and programming



P2544



DTC P2544



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for a



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P2544



- Transmission Torque Request Circuit



DTC P2544



- Transmission Torque Request Signal Message Counter Incorrect

No comments:

Post a Comment