2010 Cadillac Truck SRX FWD V6-3.0L Page 1013

2010 Cadillac Truck SRX FWD V6-3.0L Page 1013

Circuit/System Testing

1. Ignition ON, observe the DTC information with a scan tool. Verify that none of the following DTCs are set. DTC P0010, P0013, P0020,

P0023, P0335, P0336, P0340, P0341, P0345, P0346, P0365, P0366, P0390, or P0391.

瀚慖f any of the DTCs listed are set refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code

Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) for further diagnosis.

2. Idle the engine at normal operating temperature. DTCs P0016, P0017, P0018, or P0019 should not set.

瀚慖f a DTC sets, inspect for the following and repair as necessary:

* The correct installation of the camshaft sensors

* The correct installation of the crankshaft sensor

* A timing chain tensioner condition

* An incorrectly installed timing chain

* Excessive play in the timing chain

* A mechanical cam actuator that is stuck in the full advance or retard position.

* A timing chain that jumped teeth

* A crankshaft reluctor wheel that has moved in relationship to top dead center (TDC) on the crankshaft

3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the

conditions that you observed from the Freeze Frame/Failure Records data.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Timing Chain Alignment Diagram (See: Engine, Cooling and Exhaust/Engine/Timing Components/Timing Component Alignment

Marks/Locations)

* Camshaft Timing Drive Components Cleaning and Inspection (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Overhaul/81.

Camshaft Timing Drive Components Cleaning and Inspection)

* Crankshaft and Bearing Cleaning and Inspection (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Overhaul/66. Crankshaft

and Bearing Cleaning and Inspection)

P018B

DTC P018B-P018D

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P018B

- Fuel Pressure Sensor Performance

DTC P018C

- Fuel Pressure Sensor Circuit Low Voltage

DTC P018D

- Fuel Pressure Sensor Circuit High Voltage

Diagnostic Fault Information

Circuit/System Description