- X30/5 (Left voltage distributor (CAN) connector)
- Test connectors and wiring for CAN of engine compartment CAN control modules.
- Control unit
Communication with ECU required ( Measuring system )
2.1.3.4. Display CAN signals with the aid of the special tool 'Star Diagnosis CANtool'.
Important notes
- When CAN diagnosis is finished, the 8-pin CAN cable must be replaced with the diagnostic cable.
- Before values are read out from a control unit, the control unit must be reinitialized.
Continue with button F2
Important notes :For safety reasons, the vehicle must not be driven during diagnosis with special tool 'Star Diagnosis CANtool'.The diagnostic cable
must now be replaced with the 8-pin CAN cable in order to display the CAN signals.Continue with button F2
Display CAN signals with the aid of the special tool 'Star Diagnosis CANtool'.
Note
- The following CAN actual values are displayed with the aid of the special tool 'Star Diagnosis CANtool'.
Test prerequisites
- Special tool Star Diagnosis CANtool is required.
- The SDconnect CAN cable (8-pin) with MB object number 6511240099 is connected.
- The electrical connection kit with MB object number 220 589 00 99 00 is required.
- CAN highAdapter cable220 589 00 99 36
Further image can be displayed with key F7.Continue with button F2
No comments:
Post a Comment