2010 Cadillac Truck SRX FWD V6-3.0L Page 723

2010 Cadillac Truck SRX FWD V6-3.0L Page 723

Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Circuit/System Verification

Ignition ON, observe the function of the left trailer turn signal lamp and the right trailer turn signal lamp while commanding the Left Trailer Turn

Signal Lamp and the Right Trailer Turn Signal Lamp ON and OFF with a scan tool. The left trailer turn signal lamp and the right trailer turn signal

lamp should turn ON and OFF while changing between the commanded states.

Circuit/System Testing

1. Ignition OFF, disconnect the X5 harness connector at the K9 BCM.

2. Ignition ON, test for greater than 10 V between the control circuit terminal listed below and ground:

* Right trailer turn signal lamp control terminal 17

* Left trailer turn signal lamp control terminal 8

瀚慖f less than the specified value, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace

the X50 A fuse block-underhood.

3. If all the circuits test normal, replace the K9 BCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Fuse Block Replacement (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service and Repair/Removal and Replacement/Fuse

Block Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, programming and setup

With U4G

DTC B3887 or B3888 (With U4G)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B3887 02

- Trailer Left Turn Signal Circuit Short to Ground

DTC B3887 04

- Trailer Left Turn Signal Circuit Open

DTC B3888 02

- Trailer Right Turn Signal Circuit Short to Ground