Thursday, October 29, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 356

2010 Cadillac Truck SRX AWD V6-3.0L Page 356



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



Ignition ON, observe the function of the trailer tail lamps while commanding the Trailer Park Lamps ON and OFF with a scan tool. The trailer tail



lamps should turn ON and OFF while changing between the commanded states.



Circuit/System Testing



1. Ignition OFF, disconnect the trailer park lamp relay.



2. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 86 and ground.



瀚慖f the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.



3. Connect a test lamp between the control circuit terminal 85 and the B+ circuit terminal 86.



4. Command the Trailer Park Lamps ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the



commanded states.



瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace



the K9 BCM.



瀚慖f the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the K9 BCM



5. If all circuits test normal, test or replace the trailer park lamp relay.



Component Testing



Relay Test



1. Ignition OFF, disconnect the trailer park lamp relay.



2. Test for 60-180 ohm between terminals 85 and 86.



瀚慖f not within the specified range, replace the trailer park lamp relay.



3. Test for infinite resistance between the following terminals:



* 30 and 86



* 30 and 87



* 30 and 85



* 85 and 87



瀚慖f not the specified value, replace the trailer park lamp relay.



4. Install a 5 A fused jumper wire between relay terminal 85 and 12 V. Install a jumper wire between relay terminal 86 and ground. Test for less



than 2 ohm between terminals 30 and 87.



瀚慖f greater than the specified range, replace the trailer park lamp relay.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay



Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power



Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))



* Control Module References (See: Testing and Inspection/Programming and Relearning)for BCM replacement, programming and setup

No comments:

Post a Comment