Tuesday, October 27, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 832

2010 Cadillac Truck SRX AWD V6-3.0L Page 832



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Using the scan tool, locate the Invalid parameter in the Data Display.



2. Refer to the appropriate module to diagnose the invalid data signal. Do not replace the electric parking brake control module.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



C0569



DTC C0569



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions)provides an overview of each diagnostic category.



DTC Descriptor



DTC C0569 00



- System Configuration Malfunction



Circuit/System Description



If the tire type and pressure selection information is not entered with the scan tool during the body control module (BCM) setup, the tire pressure



monitor indicator icon on the instrument panel cluster (IPC) will flash for 1 minute and then remain illuminated after the ignition switch is cycled



ON and the IPC bulb check is complete. If equipped, the driver information center (DIC) will also display a service tire monitor type message.



Under these circumstances, DTC C0569 will be set and the tire type and pressure information will need to be entered for the system to function



correctly.



Conditions for Running the DTC



The ignition is ON.



Conditions for Setting the DTC



The BCM has not undergone the tire type and pressure selection setup procedure.



Action Taken When the DTC Sets



* The tire pressure monitor indicator icon on the instrument panel cluster (IPC) will flash for 1 minute and then remain illuminated after the



ignition switch is cycled ON and the IPC bulb check is complete.



* If equipped, the driver information center (DIC) displays a service tire monitor type warning message.



Conditions for Clearing the DTC



A current DTC will clear when the BCM has undergone the tire type and pressure selection setup procedure and 1 ignition cycle has occurred.

No comments:

Post a Comment