Tuesday, September 15, 2020

2010 Cadillac Truck SRX AWD V6-3.0L Page 1186

2010 Cadillac Truck SRX AWD V6-3.0L Page 1186



Circuit/System Description



The ignition system on this engine uses an individual module/coil for each cylinder. The engine control module (ECM) monitors the ignition



voltage from the fuse of each bank of coils to the ECM. The ECM uses this information to determine if the misfire is ignition coil voltage related.



Conditions for Running the DTC



* The ignition is ON.



* The ignition module supply voltage is less than 2.5 V.



* The DTCs run continuously when the above condition is met.



Conditions for Setting the DTC



The ECM detects a fault in an ignition coil control circuit for 50 out of 63 samples. Each sample runs on a 6.25 ms loop.



Action Taken When the DTC Sets



DTCs P135A and P135B are Type A DTCs.



Conditions for Clearing the DTC



DTCs P135A and P135B are Type A DTCs.



Reference Information



Schematic Reference



Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls Schematics



(LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



* Electronic Ignition System Description (See: Powertrain Management/Computers and Control Systems/Description and



Operation/Electronic Ignition System Description)



* Engine Control Module Description (See: Powertrain Management/Computers and Control Systems/Description and Operation/Engine



Control Module Description)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Engine Control Module Scan Tool Information (LF1,LFW) (See: Powertrain Management/Computers and Control Systems/Testing and



Inspection/Scan Tool Testing and Procedures)Engine Control Module Scan Tool Information (LAU) (See: Powertrain Management/Computers



and Control Systems/Testing and Inspection/Scan Tool Testing and Procedures) for scan tool information



Circuit/System Verification



With the ignition ON, observe the following scan tool parameters for each cylinder:



* Ignition Coil Supply Voltage Bank 1

No comments:

Post a Comment