2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 463

2010 Cadillac Truck Escalade/ESV RWD V8-6.2L Page 463

Conditions for Setting the DTC

B1529 03

* The BCM detects a short to ground in the B+ voltage reference circuit.

* The above condition is present for greater than 30 seconds.

B1529 07

* The BCM detects a short to voltage in the B+ voltage reference circuit.

* The above condition is present for greater than 30 seconds.

Action Taken When the DTC Sets

The BCM will ignore switch inputs.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction free ignition cycles have occurred.

Reference Information

Schematic Reference

Steering Wheel Secondary/Configurable Control Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Steering

Wheel Secondary/Configurable Control Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Steering Wheel Controls Description and Operation (See: Accessories and Optional Equipment/Description and Operation/Steering Wheel

Controls Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Ignition ON, observe the scan tool BCM SWC Bank 1 Status parameter. The reading should be idle and change between SW1-SW7 when pushing

the appropriate switch.

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.

2. Ignition ON, test for B+ between the voltage reference circuit terminal 3 and ground.

瀚慖f less than the specified value, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests

normal, replace the BCM.

瀚慖f greater than the specified value, test the voltage reference circuit for a short to voltage. If the circuit tests normal, replace the BCM.

3. If all circuits test normal, test or replace the right steering wheel control switch.

Component Testing

1. Ignition OFF, disconnect the harness connector at the right steering wheel control switch.

2. Test the resistance between the voltage reference terminal 3 and the signal terminal 4 while depressing the appropriate steering wheel

controls switch listed below.

瀚慖f not the specified range, replace the steering wheel switch.