2010 Cadillac Truck Escalade RWD V8-6.2L Page 2448

2010 Cadillac Truck Escalade RWD V8-6.2L Page 2448

Conditions for Running the DTC

* The engine is running.

* Ignition voltage is 8-18 V.

* The vehicle speed is less than 200 km/h (124 mph) for 5 seconds.

Conditions for Setting the DTC

The control solenoid valve assembly has detected a Driver Shift Control rolling count error for 8 seconds.

Action Taken When the DTC Sets

DTC P1761 is a Type B DTC.

Conditions for Clearing the DTC

DTC P1761 is a Type B DTC.

Diagnostic Aids

When attempting to set transmission control module internal DTCs, run the engine for at least 1 minute, and then shut the engine off for 30

seconds. Following this procedure will allow for a complete transmission control module shutdown. Program the transmission control module with

the latest software version and retest the DTC to see if the DTC resets.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.

Circuit/System Verification

Verify that DTC P1761 is not set.

If the DTC is set, program the Q8 control solenoid valve assembly. If the DTC resets, replace the Q8 control solenoid valve assembly.

Component Testing

Perform the Control Solenoid Valve and Transmission Control Module Assembly Inspection (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Testing and Inspection/Component Tests and General Diagnostics/2ML70 - Automatic Transmission/Control Solenoid

Valve and Transmission Control Module Assembly Inspection).

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for Q8 control solenoid valve assembly for replacement,

setup, and programming.