2010 Cadillac Truck Escalade RWD V8-6.2L Page 2449

2010 Cadillac Truck Escalade RWD V8-6.2L Page 2449

6L45/6L50/6L80/6L90 - Automatic Transmission

DTC P1761

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC P1761

- Up and Down Shift Switch Signal Circuit

Circuit/System Description

The driver shift request (DSR), also known as the TAP Up/Downshift manual shift function, allows the driver to select the desired range of gears

for current driving conditions. The DSR shift system is activated when the gear selector is in the manual position. The DSR system is deactivated in

all other range positions. When DSR is selected, a signal is sent to the body control module (BCM) and the also to the transmission control module

(TCM). Each time a signal is sent, an internal counter in the BCM and TCM increments. Both counters must have the same value. This code sets

when the rolling count value of the TCM does not match the same rolling count value sent from the BCM.

Conditions for Running the DTC

The engine run time is greater than 5 seconds.

Conditions for Setting the DTC

The TCM detects an error in the rolling count value that does not match with the BCM.

Action Taken When the DTC Sets

* DTC P1761 is a Type C DTC.

* The TCM disables TAP Shift operation.

Conditions for Clearing the DTC

DTC P1761 is a Type C DTC.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Description and Operation

Electronic Component Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and

Operation/6L45/6L50/6L80/6L90 - Automatic Transmission/Electronic Component Description)

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code