Wednesday, December 4, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 651

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 651

瀚慖f the test lamp is always ON, test the control circuit for a short to ground or a sticking horn switch. If the circuit tests normal, replace the

BCM.

瀚慖f the test lamp is always OFF, test the control circuit for a short to voltage, an open high resistance, or a horn switch which is not closing.

If the circuit tests normal, replace the BCM.

4. If all circuits test normal, replace the underhood fuse block.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Underhood Electrical Center or Junction Block Bracket Replacement (See: Maintenance/Fuses and Circuit Breakers/Fuse Block/Service and

Repair/Removal and Replacement/Underhood Electrical Center or Junction Block Bracket Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup and programming

B2850

DTC B2850, B2855, B2870, or B2875

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category

DTC Descriptor

DTC B2870 01

- Tilt Up Switch Circuit Short to Battery

DTC B2875 01

- Tilt Down Switch Circuit Short to Battery

Diagnostic Fault Information

Circuit Description

The memory seat module (MSM) receives voltage inputs from the tilt switch based on the position of the switch. The MSM then supplies battery

voltage and a ground to the tilt motor control circuits depending on which direction of movement is requested.

Conditions for Running the DTC

The ignition ON.

Conditions for Setting the DTC

The MSM detects a tilt switch input for more than 30 consecutive seconds after the tilt motor movement has stopped.

Action Taken When the DTC Sets

* The tilt motor will be deactivated.

* Memory recall functions will be disabled.

Conditions for Clearing the DTC

* A current DTC will clear when the failed switch input is no longer active.

* A history DTC will clear after 100 ignition cycles.

No comments:

Post a Comment