2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 291

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 291

4. Install a 30A fused jumper wire between relay terminal 85 and 12V. Install a jumper wire between relay terminal 86 and ground. Test for less

than 2 ohms between terminals 30 and 87.

瀚慖f greater than the specified range, replace the relay.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Relay Replacement (Attached to Wire Harness) (See: Power and Ground Distribution/Power Distribution Relay/Service and Repair/Relay

Replacement (Attached to Wire Harness))Relay Replacement (Within an Electrical Center) (See: Power and Ground Distribution/Power

Distribution Relay/Service and Repair/Relay Replacement (Within an Electrical Center))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for HVAC control module replacement, setup and

programming

B302A

DTC B302A

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B302A 00

- Telematic Requested Immobilization

Circuit/System Description

As part of the vehicle telematics enhanced services, a request may be sent to the theft deterrent module (TDM) to disable vehicle starting. If a valid

message is received by the TDM requesting that starting be disabled, the start enable message will not be sent to the engine control module (ECM).

Conditions for Setting the DTC

A valid start disable from telematics will set DTC B302A only as a history DTC.

Action Taken When the DTC Sets

Vehicle starting will be suspended and the security indicator will be illuminated.

Conditions for Clearing the DTC

* A current DTC will clear when the telematic start disable request is no longer seen.

* A history DTC will clear after 100 ignition cycles in which the telematic start disable request is not seen.

Diagnostic Aids

DTC B302A is only an indicator that a start disable request has been received from the vehicle telematics system and does not indicate a fault in the

immobilizer system. DTC B302A will only set as a history DTC.

Reference Information

Schematic Reference

Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and

Operation/Immobilizer Description and Operation)