Sunday, November 17, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 838

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 838

DTC Descriptor

DTC C056D 39

- ECU Hardware Performance Internal Electronic Failure

Circuit/System Description

The power steering control module (PSCM) continuously monitors the internal circuitry within the module.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

This DTC will set if the PSCM detects an internal malfunction within the module.

Actions Taken When DTC Sets

* DTC C056D is stored in memory.

* The driver information center (DIC) displays the SERVICE POWER STEERING warning message.

* No steering assist.

Conditions for Clearing the DTC

* A current DTC will clear on the next malfunction free ignition cycle.

* A history DTC will clear after 100 consecutive malfunction-free ignition cycles, without the repeat of the internal malfunction.

Reference Information

Schematic Reference

Power Steering Schematics (See: Steering and Suspension/Steering/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Power Steering System Description and Operation (Hydraulic Power Steering) (See: Steering and Suspension/Steering/Description and

Operation/Power Steering System Description and Operation (Hydraulic Power Steering))Power Steering System Description and Operation (EPS)

(See: Steering and Suspension/Steering/Description and Operation/Power Steering System Description and Operation (EPS))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal

Protection Equipment (PPE) and proper procedures must be followed.

The High Voltage Disabling procedure will perform the following tasks:

* Identify how to disable high voltage.

* Identify how to test for the presence of high voltage.

* Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must

No comments:

Post a Comment