Monday, November 25, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 455

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 455

The DTC will set when the rear audio/HVAC module detects a short to voltage, short to ground, or an open/high resistance in the infrared module

voltage signal circuit.

Action Taken When the DTC Sets

The rear audio/HVAC module sets the DTC and the infrared module will be disabled.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System

Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Video Entertainment System Description and Operation (Non-Headrest DVD Systems) (See: Accessories and Optional Equipment/Description

and Operation/Video Entertainment System Description and Operation (Non-Headrest DVD Systems))Video Entertainment System Description

and Operation (Dual Headrest DVD Systems) (See: Accessories and Optional Equipment/Description and Operation/Video Entertainment System

Description and Operation (Dual Headrest DVD Systems))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the infrared module.

2. Ignition OFF, test for less than 5.0 ohms between the ground circuit terminal 12 and ground.

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, rear audio ON, test for 10.0-11.0 volts between the supply voltage circuit terminal 4 and ground.

瀚慖f less than the specified range, test the voltage supply circuit for a short to ground or an open/high resistance. If the circuit tests normal,

replace the rear audio/HVAC module.

瀚慖f greater than the specified range, test the voltage supply circuit for a short to voltage. If the circuit tests normal, replace the rear

audio/HVAC module.

4. If all circuits test normal, replace the infrared module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Audio System Transceiver Module Replacement (See: Accessories and Optional Equipment/Radio, Stereo, and Compact

Disc/Radio/Stereo/Service and Repair/Audio System Transceiver Module Replacement)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for Rear Audio/HVAC Module replacement, setup,

No comments:

Post a Comment