Sunday, November 24, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 454

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 454

瀚慖f less than specified, repair the signal circuit for a short to ground.

8. If all circuits test normal, replace the BCM.

Component Testing

Ignition Switch

1. Ignition OFF, disconnect the harness connector at the ignition switch.

2. Using the Resistance Test table below, check the resistance between the terminals of the ignition switch listed in each switch position.

If any reading is not as specified, replace the ignition switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

* Ignition and Start Switch Replacement (See: Powertrain Management/Ignition System/Sensors and Switches - Ignition System/Ignition

Switch/Service and Repair)

B1449

DTC B1449

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B1449 03

- Remote Device Voltage Below Threshold

DTC B1449 07

- Remote Device Voltage Above Threshold

Diagnostic Fault Information

Circuit/System Description

The infrared module is supplied with 10.5 volts from the rear audio/HVAC module when the rear audio system is active. The infrared module is

permanently grounded at G300.

Conditions for Running the DTC

* Ignition ON.

* Battery voltage must be between 9-16 volts.

Conditions for Setting the DTC

No comments:

Post a Comment