2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 957
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Verify that no DTCs are set in the ECM or APM.
If DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic Trouble Code
(DTC) List - Vehicle).
Antilock Brake System - Non-Hybrid Less than 3900 kg (8600 lb) GVW
DTC C0561
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC C0561 71
- System Disabled Information Stored Invalid Serial Data Received
DTC C0561 72
- System Disabled Information Stored Alive Counter Incorrect or not Updated
DTC C0561 74
- System Disabled Information Stored Value of Signal Protection Calculation Incorrect
Circuit/System Description
The electronic brake control module (EBCM) receives messages from other modules over GMLAN which are needed to perform antilock brake
system (ABS), vehicle stability enhancement system (VSES), or traction control system (TCS) functions.
Conditions for Running the DTC
* The ignition switch is in the ON position.
* Ignition voltage is greater than 9.5 volts.
Conditions for Setting the DTC
The EBCM receives an invalid message from another module over GMLAN which causes EBCM to deactivate ABS, VSES, TCS, etc.
Action Taken When the DTC Sets
One or more of the following actions may occur:
* The EBCM disables the ABS/TCS/VSES for the duration of the ignition cycle.
* The dynamic rear proportioning (DRP) may be disabled and the Brake Warning indicator may turn ON.
* The Stability Caution indicator turns ON.
* The driver information center (DIC) displays the SERVICE STAB SYS message.
* The DIC displays the TRACTION FAILED message.
No comments:
Post a Comment