Wednesday, November 6, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1208

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1208

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Control Module References (See: Testing and Inspection/Programming and Relearning) for PIM replacement, setup and programming

* Drive Motor with Generator Assembly Removal - 1st Position (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Service and Repair/Overhaul/2ML70 - Automatic Transmission/8. Drive Motor with Generator Assembly Removal -

1st Position)

* Transmission Control Wiring Harness Extension Harness Removal (See: Transmission and Drivetrain/Automatic

Transmission/Transaxle/Service and Repair/Overhaul/2ML70 - Automatic Transmission/5. Transmission Control Wiring Harness Extension

Harness Removal)

P0A7E

DTC P0A7E or P1ABE

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0A7E

- Hybrid Battery Pack Overtemperature

DTC P1ABE

- Battery Energy Control Module Hybrid Battery Pack Overtemperature

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The drive motor generator battery has four hybrid battery temperature sensors. The hybrid battery temperature sensors are located on the top of the

hybrid batteries. The temperature sensor is a variable resistor that measures the temperature of the hybrid batteries. The drive motor generator

battery control module (BECM) supplies 5 V to the signal circuit and a ground for the low reference circuit. The hybrid battery temperature sensor

No comments:

Post a Comment