2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1207

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1207

1. Ignition OFF, disconnect PIM X1 connector.

2. Using the Position Sensor Specification table specifications listed below, test the position sensor resistance at the PIM X1 circuits as

indicated. Also test each circuit for a short to ground.

瀚慖f any of the circuits are not within specification, continue with testing.

瀚慖f all circuits test normal, inspect for proper terminal contact at PIM X1 connector. If PIM X1 terminal contact tests OK, perform the

Intermittent Condition Testing below.

3. Disconnect the transmission X176 24-way connector.

4. Connect the DT-48493 to the X176 24-way connector at the transmission.

5. Using the Position Sensor Specification table specifications listed below, test the position sensor resistance at the transmission X176 circuits

as indicated. Also test each circuit for a short to ground.

瀚慖f all circuits test normal, continue with testing.

瀚慖f any of the circuits are not within specification, test the internal transmission harness for the condition. If the internal transmission

harness tests OK, replace the applicable drive motor generator.

6. Disconnect DT-48493 from the transmission X176 24-way connector.

7. Connect the DT-48493 to the transmission X176 24-way connector at the vehicle harness.

8. Disconnect PIM X1 connector.

9. Using the PIM to Transmission Terminal Reference table listed below, test the vehicle harness continuity between PIM X1 connector and

transmission X176 connector. Also test these circuits for short to ground and to the shield circuit if the shield circuit is not presently

grounded to the PIM assembly.

瀚慖f any of the circuits are not within the specified range, repair the wiring harness.

瀚慖f all circuits test normal, inspect transmission connector X176 for proper terminal contact. If transmission connector X176 tests OK,

inspect the harness for an intermittent concern.

Intermittent Condition Testing

1. If possible, determine which of the position sensor circuits have the intermittent condition by reviewing the Diagnostic Fault Information

table. For example, DTCs P0C57 and P0C52 only set for a short to ground condition on either the S1 or S3 circuit.

2. Using the Position Sensor Specification table listed below, monitor the position sensor circuits at PIM X1 connector while manipulating the

applicable harness and connectors.

瀚慖f any of the circuits are not within specification, repair the harness or terminal as required. If a harness repair is indicated and external

harness damage is not evident, the most likely location for internal wire damage is near the harness clamping locations.

3. Disconnect transmission X176 connector and inspect for the following:

* Proper terminal contact

* Proper terminal retention in the connector

* Foreign material or moisture

瀚慠epair, replace or clean the connector as appropriate.

4. Reconnect all connectors and test drive the vehicle.

瀚慖f the DTC sets, replace the applicable drive motor generator and retest for DTCs. If the DTC sets, replace the PIM.